d727a50ca0
The change itself takes Management down, so the session that performs it has no
internet and no Claude. RECOVERY-CARD-vlan1-move.md is what is actually needed at
that point, on one page: the recovery path, the order, the commands, and what to
do when locked out.
The recovery path is `ssh vyos@10.0.1.252`, and the reason it is trustworthy is
that it is not routed -- the workstation is 10.0.0.210/23 and the router's LoT
leg is 10.0.1.252/23, so `ip route get` returns dev lanbr0 with no `via`. It
therefore survives Management, VRRP, the VIPs, DNS and the switch trunk all being
wrong at once. bond0.10 is untouched by the change and stays in the LAN group.
Order is switch-first, which is the opposite of what seems natural. The UniFi
controller is 192.168.1.5, on Management, reached from LoT *through vyos001*: do
the router first and you lose the controller you still need for the switch.
Two corrections to the leak test, both because it reported a router fault that
was its own:
- it counted `pgrep -f 'tcpdump -i bond0'`, so a stray tcpdump from an earlier
run satisfied the >=2 guard with none of this run's captures alive. A capture
that records nothing reads as "the router sent no reply at all".
- it believed a single silent run. Kea can be is-active and answering nothing
for tens of seconds after a restart, so the first VLANs of a loop failed and
the last passed. That produced two OPPOSITE and equally wrong conclusions
about `listen-interface` before a retry showed the pattern.
On `listen-interface`: it is a real second branch in kea-dhcp4.conf.j2 that keeps
dhcp-socket-type raw, unlike listen-address which forces udp and took DHCP down
when it was tried live. But naming the sub-interfaces explicitly left Management
DHCP dead in the sim, reproducibly, against a clean control with interfaces:["*"].
Not adopted, and not needed -- the address move is the proven fix.
Co-Authored-By: Claude Opus 5 (1M context) <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01DMVzWZgiKW2wquf5z8S1yH